Wire EDM Parts
The sPINner has the following effects on Wire EDM parts
• Removing small burrs on the cutting edges, the pins are small and can reach holes or splits.
• Slightly rounding sharp cutting edges and make the parts smooth. The accuracy will never be affected.
• The rounding effect is consistent no matter on outside edges or insides edge in holes or splits.
• Polishing the surface, remove rust layer, increase metallic luster.
＊Continuous burrs are not able to be removed.
Example of Deburring & Slight Rounding Cutting Edges
Example of Deburring & Slight Rounding Cutting Edges
Example of Deburring & Slight Rounding Holes
Example of Deburring & Slight Rounding Holes
Example of Deburring & Polishing Thin Parts
Example of Deburring & Polishing Thin Parts
Example of Deburring & Polishing Thin Parts
